Honeycomb ventilation 9500 Shielded vent panels for ventilation and heating
Honeycomb vents are used to shield openings for heating and ventilation against undesirable electromagnetic waves.
The aluminium honeycomb vent panels are supplied in rigid aluminium frames, pre-drilled or with fasteners made to your specifications or flow drilled thread holes.
If a very high shielding level is required, the use of cross-cell honeycombs is recommended. These are made from two pieces of 6.35 mm or 12.7 mm thick honeycomb within a single frame. The shielding performance will improve at the expense of slightly increased air flow resistance.
Standard and cross-cell version: (Cross-cell version for higher shielding performance)
Approximately 95% of the honeycomb vents are made to customer specifications, and are all made to order.
Standard delivery time: less than two weeks.
Benefits
Light weight
High shielding performance
Very low air-flow resistance
Reduction of turbulence
Options
Cross-cell honeycomb for extra high shielding performance
In the table below some common types are specified to illustrate the required information. Hole diameter P is standard 3.5mm but it ca be delivered in any other size. Also available with screw apertures or inserts.
Most of the honeycomb ventilation panels are made according to customer’s specifications. For standard part number see table above. When ordering honeycomb vents, the following information should be provided:
Series
Height (mm)
Width (mm)
Frame type
Drill patern
Gasket materiaal
9500
200
200
C
DS
A
DS : standard drill patern DC : custom drill patern
A : Amucor K : Knitted wire mesh N : No gasket material
Get a price quotation
Do you want to receive a price quotation for Shielded ventilation within 24 hours, than please click on the right button.
Request a product sample
Click on the right button to request a free sample of Shielded ventilation.
.jpg "Honeycomb shielding performance")
